Product Description
This is a special remote shutter release cable called a Pre-Trigger Cable. A Pre-Trigger cable controls both the half-press and full-press function of your remote camera’s shutter release. When a camera is “pre-triggered”, it is like holding your camera’s shutter release button in the half-pressed or metering/focusing position.
Compatible with the following radios:
- PlusX: Use this cable with the PlusX to trigger the camera.
- Plus III: Use this cable with the Plus III’s exclusive 2-stage trigger to wake-up or focus your remote camera just like using the camera’s shutter release button.
- FlexTT5: This cable is required for auto-relay mode with E-TTL, or other remote triggering with the FlexTT5. You can use a CM-N3-P cable or CM-N3 standard cable with a FlexTT5, but your remote camera will not be able to relay an E-TTL signal to Speedlites. The FlexTT5 does not support the 2-stage trigger function.
- MultiMAX with –ACC port: Enable a remote zone with your hand-held MultiMAX, and your remote MultiMAX will wake up its remote camera with this cable. As long as the zone is turned on, the remote camera will stay awake and respond more quickly and consistently, but also consume the camera's batteries much more quickly. When the remote zone is disabled, the camera will enter its normal sleep modes. The MultiMAX does not support the 2-stage trigger function.
Compatible with cameras using Canon's N3 remote terminal including:
- Canon:
- EOS 20D
- EOS 30D
- EOS 40D
- EOS 50D
- EOS D30
- EOS D60
- EOS D2000
- EOS-1V
- EOS-1V HS
- EOS-3
- EOS 5D
- EOS 5D Mark II
- EOS 5D Mark III
- EOS 6D*
- EOS 7D
- EOS-1D Mark II
- EOS-1D Mark IIN
- EOS-1D Mark III
- EOS-1D Mark IV
- EOS-1Ds
- EOS-1Ds Mark II
- EOS-1Ds Mark III
- EOS-1D X*
*NOTE: The 1D X and 6D do not support TTL operation at this time.
Condition: Brand new in original manufacturer's packaging
10.31.2013AL
Additional Details
| Unavailable | Discontinued or unavailable to Special Order |
|---|
